Appro WH300 Guia do Utilizador descarregar pdf (Página 23)

Rev. 2.0

1/23/06

Appro WH300 User’s Guide 22

3.7.5 Installing an Add-in Board

You may want to install an operating system before installing any add-in boards. If so,

skip this step and return to it when you are ready.

CAUTIONS

Do not overload the server board by installing add-in

boards that draw excessive current.

Add-in boards can be extremely sensitive to ESD and always

require careful handling. After removing the board from its

protective wrapper or from the server board, place it

component side up on a grounded, static free surface or

conductive foam pad if available. Do not slide the board

over any surface.

1. Open the back panel PCI Add-in Card Retention Device by pressing open from

the inside of the chassis.

2. Remove the PCI slot shield, if it has not already been removed, by pushing the

shield out from the inside of the chassis.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 36 37

Sem comentários

Appro WH300 Guia do Utilizador Página 23